Electronics for Embedded and IoT Engineers
Basic electronics for embedded work is the study of voltage, current, resistance and the components that shape them. Ohm's law links the three, resistors, capacitors and diodes condition signals, transistors switch loads, and a multimeter and datasheet let you check that a circuit around a microcontroller behaves as designed.
Stage: Foundations · Part of the Embedded and IoT Engineer roadmap · Last reviewed 19 November 2026
What to learn in Electronics
- Apply Ohm's law to size a resistor that limits current through an LED
- Build a voltage divider and explain when it is used to read a sensor
- Explain the role of decoupling capacitors and pull-up resistors near a microcontroller
- Use a transistor or MOSFET to switch a load larger than a pin can drive
- Measure voltage and continuity with a multimeter and read a component datasheet
Electronics interview questions
Why does an LED need a series resistor?
An LED conducts almost freely once its forward voltage is exceeded, so current would rise until it burns out. The resistor sets the current using Ohm's law: subtract the LED's forward voltage from the supply, then divide by the desired current.
What is a pull-up resistor and why use one?
A pull-up ties an input pin to the supply through a resistor so it reads high when nothing else drives it. A button then pulls the line to ground when pressed. Without it, a floating input picks up noise and reads random values.
Where Electronics fits in the Embedded and IoT Engineer roadmap
Electronics belongs to the Foundations stage (beginner level). Electronics and C.
Other units in this stage
Back to the full Embedded and IoT Engineer roadmap